Lost-wax casting reproduces your model in great detail, but metal has its rules. If your design follows them, it will pass our automatic check the first time.
Export your file well
- STL format, binary if possible.
- Modeled in millimeters. If you worked in centimeters or inches, you can say so when you upload it.
- A closed mesh (no holes or loose faces), in one piece.
- Enough resolution that curves do not look faceted.
Wall thickness
Very thin walls do not fill properly, or break when the piece is finished.
When you quote, a thickness map shows in red whatever falls under the minimum.
Details and lettering
- Raised reliefs and letters: at least 0.4 mm high, with strokes 0.35 mm wide.
- Engravings: at least 0.3 mm wide and deep.
- Details finer than that are usually lost in polishing.
Cavities and thick sections
- A completely sealed cavity cannot be cast: the investment gets trapped inside. Fill it, or open it with two holes of at least 1.5 mm.
- Solid sections thicker than 6 to 8 mm are heavy and can come out porous. Hollow the piece when you can: it saves metal and improves the result.
Size
We cast pieces up to 100 × 100 × 150 mm. If yours is larger, we review it to see whether it can be made in parts.